Respironics SleepEasy Manual do Utilizador descarregar pdf (Página 13)

11Us e r Ma n U a l

Heated Humidifier Feature

The Integrated Heated Humidifier is a feature that may reduce nasal dryness and irritation by adding moisture and

heat to the airflow. This feature can be enabled or disabled by your home care provider.

If the heated humidifier is enabled on your device, press the HEAT button on the top of the device. The Humidifier

Setting screen will appear flashing, shown below. You can enter this screen from either the standby or operate screen.

Note: If the heated humidifier feature is disabled by the home care provider, nothing will happen when you press

the HEAT button.

Humidifier Setting Screen

You can increase or decrease the humidifier heat settings by pressing the + or – buttons. The possible settings are

from 0 (off) to 5 which is the highest setting. Once you have chosen your desired setting, you can either press the

HEAT button again or just wait a few moments and the new setting will be saved. The screen will then automatically

return to either the standby or operate screen.

Note: This screen will not display if your provider has not enabled the humidifier on your device.

Ramp Feature

You can press the RAMP button to activate the Ramp feature, if your provider has enabled this feature.

The device is equipped with an optional ramp feature that your home care provider can enable or disable. This

feature reduces the air pressure when you are trying to fall asleep and then gradually increases (ramps) the pressure

until your prescription setting is reached, allowing you to fall asleep more comfortably.

If ramp is enabled on your device, after you turn on the airflow, press the RAMP button on the top of the device. You

can use the RAMP button as often as you wish during the night.

Note: If the ramp feature is disabled, nothing will happen when you press the RAMP button.

In order to adjust the Ramp Starting Pressure, press and hold the RAMP button for approximately 3 seconds.

The Ramp Starting Pressure Screen will appear flashing, shown here. It can be entered from either the standby or

operate screen.

Ramp Starting Pressure Screen

You can increase or decrease the ramp starting pressure in 0.5 cm H

O increments by pressing the + or – buttons.

The default setting is 4 cm H

O. You can adjust the setting from 4 cm H

O to the CPAP pressure setting. Once you

have chosen your desired setting, you can either press the RAMP button again or just wait a few moments and the

new setting will be saved. The screen will then automatically return to either the standby or operate screen.

Note: This screen will not display if your provider has not enabled Ramp on your device.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sem comentários

Respironics SleepEasy Manual do Utilizador Página 13